Edit

Any DSCP Mapping profile (including the default profile) can be edited. When editing a DSCP Mapping profile, Panorama PON automatically updates all OLTs that are using that profile.

Edit a DSCP Mapping profile as follows:

1. Panorama PON saves the edited profile to the server database and generates an internal list of all OLTs using the profile.
2. Panorama PON sends the profile updates to the OLTs that use the profile.
3. Panorama PON deactivates and reactivates each connection to re-synchronize the with the provisioned settings.

Only one profile can be edited at a time.

This procedure is momentarily service-affecting to all connections associated with the profile. The profile change causes a re-synchronization of the connection.

Use the following procedure to edit an DSCP Mapping profile:

1. Select the Profile Name from the Profile/Template List to edit and click the Edit a New Profile () icon in the Main Menu bar or right-click the profile name and use the pop-up menu to select Edit. The Edit DSCP Mapping Profile dialog is displayed.
   
   
2. In the Edit DSCP Mapping Profile dialog, edit the P-Bits as desired for the network behavior change, and click on the Apply button.
3. An empty DSCP Mapping Profile Edit Status will be displayed during the update, to be followed by the status.

Note 2: To open and monitor the DSCP Mapping Profile Edit Status dialog, click the View Edit Status icon () in the toolbar. If the process finishes with no errors, Panorama PON displays the message Profile Edit is not in progress.

4. When finished, with no errors reported, click on the Close button.

 If errors are reported, the exceptions appear in the Error Status section. Do one of the following:

• Click Retry to update these OLTs again
• Click Terminate to end the process with the errors.

5. When terminating a process with errors, a warning message confirms that the process was aborted. In the dialog that appears, click on the OK button.

6. When finished, click on the Close button. 
7. If no further profiles are to be created, click on the Cancel button to close the Edit DSCP Mapping Profile dialog.
8. When finished, click on the Close button. 
9. Click on the Close buttonagain to exit the Ethernet Port Profiles screen.