››

OLT CLI Manual

This manual documents the Command Line Interface (CLI) for Tellabs OLT products.

It is used primarily for fault diagnostics and trouble-clearing procedures. The craft interface functions are available via ssh for remote sessions or a direct serial port connection, typically on the front faceplate of the OLT.

It also provides the ability to Turnup and provision the OLT so that it can be added to the Element Management System (EMS). The CLI supports commands to allow CLI users to configure and/or get status information for all but a few system features and functions.

Document Revisions

Revision	Date	Notes and Revision Highlights
Revision A	Jan 2017	Initial Release of Document
Revision B	Mar 2018	Updated Manual
Revision C	May 2024	Updated and Converted to Online Document NOTE: This revision applies to SR31.4.18, OLR Version SR31.4_605054 and above Revision Highlights added NE Bridge-Edit (Applies to EMS-SR31.4, OLT-605054 and above) Allows Unknown Unicast Flood Blocking (UUFB) added NE DhcpSnoopInspection DhcpSnoopInspection - DSI related operations added NE DynamicArpInspection DynamicArpInspection - DAI related operations added NE ICMP ICMP - icmp configuration added NE equipment equipment - Equipment related operations. added NE monitor monitor - Ethernet Packet Monitor related commands added interface flowmirroring flowmirroring - legacy flowmirroring and portmirroring added multicast multicast- displays information about downstream multicast groups added NE security mutual-auth - enable/disable mutual authentication. yubikey- SSH Yubikey Token Utility added NE session session- packet monitor commands create, delete, edit, start, stop, show, status, and statistics added ONT security mutual-auth- enable/disable mutual authentication. yubikey - SSH Yubikey Token Utility added switchloads - Switches the System to Standby load. added version - Shows the current version of the system. added templates - Added a port template. added VLAN - Provides options to create, edit, delete and display. added DSCP - A DiffServ-CodePoint mapping profile and related operations
Revision D	Aug 2024	Reconfigured any CLI Commands associated with the OLT2/OIU2 change of NE to OLT to reflect the change. Added an OLT Commands (OLT2 only) section to reflect the OLT2/OIU2 change of NE to OLT.