Reset Factory Defaults

Note: Log on with Admin user privileges to perform this procedure.

This section contains the procedures to perform a Restore Default.

The resetdefaults command enables the administrator to reset the ESU board back to factory defaults, removing all the current provisioning information. 

Warning:  Unless a backup has been performed of the current database, there is no way to recover the system configuration data.

• Command Path - resetdefaults
• Command Path - olt resetdefaults (OLT2 only)

  Note: **=olt - Add olt to the CLI Command Path for OLT2.

1. From an ESUx> prompt, input ** resetdefaults, and press Enter. Output similar to the following is displayed:

   ************************************************************* * Warning all provisioning and board specific configuration * * will be lost and the complete shelf will be reset * *************************************************************

    

   Warning: This command will remove all provisioning information, proceed with caution at the next prompt.

2. The next prompt will ask to continue.

   Do you wish to continue(Yes/No) :

3. Input Yes and press Enter to return the board to factory defaults.

4. Input No and press Enter to return to the ESUx> command prompt.
    

   Note: The prompt will return until the user enters a correct answer.

Previous    Next