RTP Status

The rtpstat command displays the current status of an active Real-time Transport Protocol (RTP) Monitor command.

Note: Traffic monitoring automatically terminates 15 minutes after monitoring is enabled or 15 minutes after the RTPSTAT command is entered (whichever occurs last). Each RTPSTAT command extends traffic monitoring for 15 minutes.

• Command - rtpstat

Note: The number of columns displayed corresponds to the number of flows being monitored.

1. Enable rtpmon as shown below. See rtpmon for procedure.

   ESUx> rtpmon enable 200 239.1.1.6 <enter> RTPMON ENABLED ESUx> _

2. From the ESUx> command line, input rtpstat, and press Enter. The following status is displayed.

   ESUx> rtpstat <enter> VLAN 200 Src IP 0.0.0.0 Dest IP 172.28.122.100 #Non RTP Packets 0 #RTP Flows 2 Stream Counters 0 packets

3. After the status is displayed, at the ESUx> command line, input rtpmon disable and press Enter.

   ESUx> rtpmon disable <enter>

4. If there is no rtpman command enabled, the following error message is displayed:

   ESUx> rtpmon <enter> ESUx> Failed to get metrics information. Error code = -1 ESUx> _​

    

   ---

   Previous  |  Next