Edit

Provides options to edit Ethernet port (PORT) profiles.

Note: * = required parameter]

• Command Path - profile>port
• Object - port
• Actions -
  • edit - Edit a PORT profile
    • * name= - Name of PORT profile
    • dai-trust-state= - DAI Trust State
      • trusted|untrusted (default)
    • link-flap-violation= - Link Flap Violation
      • enabled | disabled (default)
    • link-trap-notification= - Link Trap Notification
      • enabled | disabled (default)
    • loopback-violation= - Loopback Violation
      • enabled | disabled (default)
    • max-mac-violation= - Maximum mac Violation
      • enabled | disabled (default)
    • max-macs= - Maximum mac addresses allowed
      • 1 - 255 (default 16)
    • mdix= - auto-crossover cable support
      • enabled (default)| disabled 
    • pause= - MAC pause flow-control
      • none|tx|rx| tx-rx (default)
    • phy-hold-time= - Phy Hold Time
      • -1|0-65535 | 5 (default)
    • rxburst= - Burst size (in Bytes) (or 0 to disable)
      • 0 - 99999 (default 0)
    • rxpeak= - Peak bitrate rate (in kbps) of the port (or 0 to disable)
      • 0 - 10000000 (default 0)
    • speed= - the fixed or auto-negotiated maximum line speed of the port
      • 10BaseT | 100BaseT | 1000BaseT-Auto (default)
    • txburst= - Burst size (in Bytes) (or 0 to disable)
      • 0 - 99999 (default 0)
    • txpeak =- Peak bitrate rate (in kbps) of the port (or 0 to disable)
      • 0 - 10000000 (default 0)
         

1. From the ESUx> command line, input profile port edit name=TellabscliTest speed=10BaseT, and press Enter. Output similar to the following is displayed:

   ESUx> profile port create name=TellabsCliTest speed=10BaseT <enter> success ESUx> _

Previous  |  Next